LATEST
NEETBy Pareeksha Editorial Team· ⏱ 9 min read

NEET Physics Numericals: A Fast, Reliable Solving Method

Share𝕏fin
Alongside this guide

Find study material for your next topic

Browse the Reading Room and preview a chapter before choosing what to study.

Browse study material →
NEET Physics Numericals: A Fast, Reliable Solving Method
On this page
  1. Habit 1: Read the last line first
  2. Habit 2: Use ratios, not full calculations
  3. Habit 3: Estimate before you calculate
  4. Habit 4: Handle numbers smartly
  5. Habit 5: Eliminate options without solving
  6. Habit 6: Memorise standard results
  7. When to stop and move on
  8. A daily routine to build speed
  9. Frequently asked questions
  10. How much time should one Physics numerical take in NEET?
  11. Are shortcut tricks reliable?
  12. How do I get faster at arithmetic?
  13. Should I use $g = 10$ or $g = 9.8$?
  14. What if my answer is not among the options?

As per the NEET (UG) 2026 information bulletin, the paper runs for 180 minutes, and the 2026 re-exam paper had 180 questions, 45 of them in Physics. That is one minute per question on average, and Biology questions, which are mostly recall, usually take less. So Physics gets a little more, but a numerical that takes four minutes still costs you the time of two or three other questions.

Speed in Physics numericals does not come from doing arithmetic faster. It comes from doing less arithmetic. This guide shows six habits that cut the working down, each demonstrated on a real NEET question with its official answer.

Habit 1: Read the last line first

Before reading the data, read what is asked and in which unit. "The ratio", "the percentage change", "in keV", "in nJ" all change how you work. A question that asks for a ratio usually needs no numbers at all for the constants; a question that asks for keV tells you to keep three or four significant figures.

Habit 2: Use ratios, not full calculations

Most NEET numericals compare two situations. When they do, write the proportionality, cancel everything that stays the same, and calculate only what changes.

Past question (NEET (UG) 2025, Q5). The kinetic energies of two similar cars A and B are 100 J and 225 J respectively. On applying breaks, car A stops after 1000 m and car B stops after 1500 m. If $F_A$ and $F_B$ are the forces applied by the breaks on cars A and B, respectively, then the ratio $F_A/F_B$ is

(A) $\frac{3}{2}$ (B) $\frac{2}{3}$ (C) $\frac{1}{3}$ (D) $\frac{1}{2}$

Official answer: (B). The work-energy theorem gives $F \times s = K$, so $F = \frac{K}{s}$. Then $\frac{F_A}{F_B} = \frac{100/1000}{225/1500} = \frac{0.10}{0.15} = \frac{2}{3}$. No masses or speeds are needed.

Past question (NEET (UG) 2024, Q8). The mass of a planet is $\frac{1}{10}$th that of the earth and its diameter is half that of the earth. The acceleration due to gravity on that planet is :

(A) $4.9\ \mathrm{m\,s^{-2}}$ (B) $3.92\ \mathrm{m\,s^{-2}}$ (C) $19.6\ \mathrm{m\,s^{-2}}$ (D) $9.8\ \mathrm{m\,s^{-2}}$

Official answer: (B). $g \propto \frac{M}{R^2}$, so $\frac{g_p}{g_e} = \frac{1/10}{(1/2)^2} = \frac{4}{10} = 0.4$, and $g_p = 0.4 \times 9.8 = 3.92$ m/s². $G$ never appears.

Past question (NEET (UG) 2022, Q159). Two pendulums of length 121 cm and 100 cm start vibrating in phase. At some instant, the two are at their mean position in the same phase. The minimum number of vibrations of the shorter pendulum after which the two are again in phase at the mean position is :

(A) 11 (B) 9 (C) 10 (D) 8

Official answer: (A). $T \propto \sqrt l$, so the periods are in the ratio $\sqrt{121} : \sqrt{100} = 11 : 10$. In the time the longer pendulum makes 10 vibrations, the shorter makes 11, and they are back in step. The lengths were chosen as perfect squares to make the ratio exact; spotting that is half the question.

The proportionalities that come up most often:

Relation Proportionality
Pendulum period $T \propto \sqrt{l}$, $T \propto \frac{1}{\sqrt g}$
Spring–mass period $T \propto \sqrt{\frac{m}{k}}$
Surface gravity $g \propto \frac{M}{R^2}$
Escape speed $v_e \propto \sqrt{\frac{M}{R}}$
Orbital period $T \propto r^{3/2}$
Speed of sound in a gas, rms speed $\propto \sqrt{T}$ (kelvin)
Wire resistance $R \propto \frac{l}{A}$; stretched $n$ times, $R \to n^2R$
Kinetic energy at fixed momentum $K \propto \frac{1}{m}$
de Broglie wavelength at fixed energy $\lambda \propto \frac{1}{\sqrt m}$
Field of a point charge, gravitational force $\propto \frac{1}{r^2}$

Past question (NEET (UG) 2022 Phase 2, Q177). An organ pipe filled with a gas at $27^\circ$C resonates at 400 Hz in its fundamental mode. If it is filled with the same gas at $90^\circ$C, the resonance frequency at the same mode will be

(A) 512 Hz (B) 420 Hz (C) 440 Hz (D) 484 Hz

Official answer: (C). The pipe length fixes the wavelength, so $f \propto v \propto \sqrt T$. In kelvin, $\frac{363}{300} = 1.21$, and $\sqrt{1.21} = 1.1$, so $f = 440$ Hz. Again the numbers were chosen to give a perfect square once converted to kelvin; if you forget to convert, you get $\sqrt{90/27}$, which does not simplify, and that is a signal you have gone wrong.

Habit 3: Estimate before you calculate

Look at the options before working. If they differ by factors of 10 or 1000, you only need the order of magnitude and the leading digits. If they are close (like 3726, 3730, 3736 and 3740 keV in a 2026 re-exam question), you need exact arithmetic, and you should slow down.

Past question (NEET (UG) 2026, cancelled May sitting, Q159). The power of a crane, which lifts a mass of 1000 kg to a height of 20 m in 10 s is: $(g=9.8\ \mathrm{m}/{\mathrm{s}}^{2})$

(A) 19.6 W (B) 39.2 W (C) 19.6 kW (D) 39.2 kW

Official answer: (C). $P = \frac{mgh}{t} = \frac{1000 \times 9.8 \times 20}{10} = 19\,600$ W $= 19.6$ kW. The options differ by a factor of 2 and a factor of 1000, so even a rough $1000 \times 10 \times 2 = 20\,000$ W picks (C). The factor-of-2 options catch anyone who mixes this up with a different formula; the factor-of-1000 options catch anyone who drops the "k".

Habit 4: Handle numbers smartly

  • Write every number as $a \times 10^n$ before multiplying, and add the powers separately.
  • Convert to SI at the start: cm to m, g to kg, °C to K, mA to A, L to m³.
  • Keep these values ready:
Value Approximation
$\sqrt 2$ 1.414
$\sqrt 3$ 1.732
$\pi^2$ about 9.87, often taken as 10
$\frac{1}{\pi}$ 0.318
$\ln 2$ 0.693
$hc$ 1240 eV nm
$\frac{1}{4\pi\varepsilon_0}$ $9 \times 10^9$ SI
$\mu_0$ $4\pi \times 10^{-7}$ SI
1 eV $1.6 \times 10^{-19}$ J
1 u 931.5 MeV
  • Know squares up to 25 and the cubes of 1 to 10. They make "nice-number" questions, like the 121 cm and 100 cm pendulums above, obvious.

Habit 5: Eliminate options without solving

  • Dimensions. An option with the wrong dimensions is wrong. In a NEET 2025 question comparing the wavelengths of a photon and an electron of equal energy, only one option was dimensionless, and a ratio of wavelengths must be.
  • Limiting cases. Put an extreme value in: if the angle is zero, if a mass becomes very large, if a resistance is zero. The correct formula must give a sensible result.
  • Size of change. If a quantity must increase, discard options below the starting value; then estimate how much. In the organ pipe question, the kelvin temperature rises about 21%, so the frequency, which goes as its square root, must rise by roughly half that, about 10%. That rules out 484 Hz and 512 Hz at a glance.

Habit 6: Memorise standard results

Deriving a result in the exam wastes time when the result is standard. Results worth having ready:

  • Range is maximum at $45^\circ$ and equal for $\theta$ and $90^\circ - \theta$
  • Average speed over equal distances: $\frac{2v_1v_2}{v_1 + v_2}$
  • Equal masses in a 1D elastic collision exchange velocities
  • Escape speed $= \sqrt 2 \times$ orbital speed near the surface
  • Satellite: kinetic energy $= -$ total energy; potential energy $= 2 \times$ total energy
  • $n$ equal resistors in parallel: $\frac{R}{n}$; $n$ equal capacitors in series: $\frac{C}{n}$
  • After $n$ half-lives, $\frac{1}{2^n}$ remains
  • Carnot efficiency $1 - \frac{T_2}{T_1}$ in kelvin

Past question (NEET (UG) 2023, Q11). A Carnot engine has an efficiency of 50% when its source is at a temperature $327^\circ$ C. The temperature of the sink is :

(A) $27^\circ$ C (B) $15^\circ$ C (C) $100^\circ$ C (D) $200^\circ$ C

Official answer: (A). $T_1 = 600$ K. With $\eta = 0.5$, $T_2 = 0.5 \times 600 = 300$ K $= 27^\circ$C. Halving 327 °C directly would give about 164 °C, which is not an option; the examiners still rely on students who forget kelvin.

When to stop and move on

Set a 30-second rule. If after half a minute you cannot see which formula or principle applies, mark the question and move on. Come back after finishing the section. A question you skip costs nothing; a guess that is wrong costs a mark. Our guide to negative marking and attempt strategy covers when an educated guess is worth it, and the time management guide covers how to split the 180 minutes.

A daily routine to build speed

  1. Timed sets. Fifteen questions from one chapter in 15 minutes. Chapter-wise tests in exactly this format are on the NEET dashboard (login needed).
  2. Second pass. For each question that took over two minutes, find the shortcut: was there a ratio, a standard result or an option that could be eliminated?
  3. Log errors. Note whether each wrong answer was a concept, formula, arithmetic, unit or reading error. The NEET error log guide shows a simple format, and the common Physics mistakes guide lists the usual ones.
  4. Past papers. Once a week, solve the Physics section of a past paper under time. All 51 papers are on the past-paper page.

The mechanics formula sheet lists the equations behind most of these ratios. The worked examples in each chapter of the NEET Physics books, such as Gravitation and Properties of Matter and Oscillations and Waves, show the same methods at chapter level. The syllabus page and the chapter weightage page show where to focus. For a quick, free check of your speed, the 10-question NEET mini mock needs no sign-up to start.

Frequently asked questions

How much time should one Physics numerical take in NEET?

Aim for about a minute on average. Simple substitutions should take 30–40 seconds, which leaves time for the few longer questions a paper may contain. If a question passes two minutes, mark it and come back.

Are shortcut tricks reliable?

The ratio method, estimation and dimension checks are not tricks; they are physics and always valid. Memorised "trick formulas" for narrow problem types are less reliable, because a small change in the question breaks them. Learn standard results that come from the main formulas.

How do I get faster at arithmetic?

Do less of it. Convert to powers of ten, cancel before multiplying, and use ratios. Then practise squares, square roots and common fractions for ten minutes a day for two weeks.

Should I use $g = 10$ or $g = 9.8$?

Use what the question gives. If the options are far apart, 10 is fine for estimating. If they are close, use the exact value stated.

What if my answer is not among the options?

First check units and powers of ten, then the kelvin conversion, then whether you used the right formula (for example, near point versus normal adjustment). If none of these fixes it in 30 seconds, move on and return later.

Share:𝕏fin
Put what you read into practice

Find study material for your next topic

Browse the Reading Room and preview a chapter before choosing what to study.

Browse study material →

Make this reading part of your preparation

Create your free account to bookmark Reading Room chapters and track your practice scores. You’ll return to this article after signing in.

By continuing, you agree to our terms and privacy policy.

No payment needed. Already registered? Use the same options to sign in.

Comments (0)

Sign in to join the discussion.

No comments yet. Be the first to share your thoughts.