Laws of Motion is where mechanics stops being about describing motion and starts explaining it. It is also one of the most consistent chapters in NEET: in Pareeksha's data it has been asked in every NEET year from 2016 to 2026. The questions are rarely long, but they reward a clean free-body diagram and punish guesswork about friction.
This post uses Pareeksha's own counts from the digitised NEET and AIPMT past papers, then works through five past questions with their official answers.
How often NEET asks Laws of Motion
Across Pareeksha's 51 digitised papers from 1988 to 2026, 38 questions are tagged to this chapter. In the 18 NEET sittings from 2016 to 2026, it had 18 of 531 tagged Physics questions, placing it 12th of 29 Physics chapters.
The chapter has grown in recent papers. The 8 NEET papers from 2016 to 2020 had 5 questions, about 0.6 per paper. The 10 papers from 2021 to 2026 had 13, about 1.3 per paper, which is 3.7% of the 347 tagged Physics questions in that period.
| NEET year (all sittings combined) | Questions |
|---|---|
| 2013 | 1 |
| 2016 | 1 |
| 2017 | 1 |
| 2018 | 1 |
| 2019 | 1 |
| 2020 | 1 |
| 2021 | 2 |
| 2022 | 1 |
| 2023 | 2 |
| 2024 | 3 |
| 2025 | 3 |
| 2026 | 2 |
Some years had more than one sitting, and a few digitised papers are a few questions short, so treat these as close counts. The full Physics table is on the NEET chapter-wise weightage page.
What the questions test
- Friction. The limit of static friction, the largest acceleration friction can provide, and bodies sliding on rough inclines.
- Dynamics of circular motion. Tension as centripetal force, banked roads, and the speed at which no friction is needed.
- Newton's second law and momentum. Force as rate of change of momentum, impulse, and apparent weight in lifts.
- Connected bodies. Blocks joined by strings over pulleys. These almost always come with a figure, so they are not in the sample below, but they are worth practising.
Solved NEET past questions
Each question below is copied from the paper with its official answer. The working is ours.
1. Largest acceleration before a box slips
From NEET 2026 (cancelled May sitting), Q146.
A box of mass 15 kg is kept on the floor of a stationary trolley. The coefficient of static friction between the box and the trolley is 0.12 . Keeping the box in stationary state over the trolley, the maximum acceleration with which the trolley can be moved horizontally in $\mathrm{m}{\mathrm{s}}^{-2}$ is:
$(g=10\ \mathrm{m}/{\mathrm{s}}^{2})$
- (A) 2.1
- (B) 1.8
- (C) 1.5
- (D) 1.2
Official answer: (D)
Solution. The only horizontal force on the box is static friction. Its largest value is $\mu_s mg$, so the largest acceleration it can give the box is $a_{max} = \mu_s g = 0.12 \times 10 = 1.2\ \mathrm{m\,s^{-2}}$. The 15 kg is given but cancels; questions often include a number you do not need.
2. Banked track with no tyre wear
From NEET 2026 re-exam, Q41.
A car travels on a circular racetrack of radius 50 m, which is banked at an angle $\theta$. If the car travels at a speed $10\ \mathrm{ms^{-1}}$, then the wear and tear on its tyres is minimum. Taking the acceleration due to gravity to be $10\ \mathrm{ms^{-2}}$, the value of $\theta$ is :
- (A) $\tan^{-1}\left(\frac{1}{5}\right)$
- (B) $\tan^{-1}\left(\frac{2}{5}\right)$
- (C) $\tan^{-1}\left(\sqrt{3}/2\right)$
- (D) $\tan^{-1}\left(2\sqrt{3}\right)$
Official answer: (A)
Solution. "Minimum wear and tear" is the question's way of saying that no friction is needed. At that speed the normal reaction alone supplies the centripetal force, and $\tan\theta = \frac{v^2}{rg} = \frac{100}{500} = \frac{1}{5}$.
3. Rough and smooth inclines
From NEET 2025, Q4.
There are two inclined surfaces of equal length ($L$) and same angle of inclination $45^\circ$ with the horizontal. One of them is rough and the other is perfectly smooth. A given body takes 2 times as much time to slide down on rough surface than on the smooth surface. The coefficient of kinetic friction ($\mu_k$) between the object and the rough surface is close to
- (A) 0.25
- (B) 0.40
- (C) 0.5
- (D) 0.75
Official answer: (D)
Solution. From rest over the same length, $L = \frac{1}{2}at^2$, so $t \propto \frac{1}{\sqrt{a}}$. Twice the time means a quarter of the acceleration. On the smooth incline $a = g\sin 45^\circ$; on the rough one $a = g(\sin 45^\circ - \mu_k\cos 45^\circ)$. Since $\sin 45^\circ = \cos 45^\circ$, $1 - \mu_k = \frac{1}{4}$, so $\mu_k = 0.75$. The general result is $\mu_k = \tan\theta\left(1 - \frac{1}{n^2}\right)$ when the rough incline takes n times as long.
4. Tension quadrupled, new speed
From NEET 2024 re-exam, Q152.
A bob is whirled in a horizontal circle by means of a string at an initial speed of $10\ \mathrm{rpm}$. If the tension in the string is quadrupled while keeping the radius constant, the new speed is:
- (A) 20 rpm
- (B) 40 rpm
- (C) 5 rpm
- (D) 10 rpm
Official answer: (A)
Solution. The tension provides the centripetal force, $T = m\omega^2 r$. With m and r fixed, $\omega \propto \sqrt{T}$. Four times the tension gives twice the angular speed: 20 rpm.
5. Speed doubled, new tension
From NEET 2024, Q22.
A bob is whirled in a horizontal plane by means of a string with an initial speed of $\omega$ rpm. The tension in the string is $T$. If speed becomes $2\omega$ while keeping the same radius, the tension in the string becomes :
- (A) $\frac{T}{4}$
- (B) $\sqrt{2}T$
- (C) $T$
- (D) $4T$
Official answer: (D)
Solution. From $T = m\omega^2 r$, tension goes as the square of angular speed. Doubling ω gives $4T$. Notice that questions 4 and 5 are the same relation asked in reverse, in two sittings of the same year. Solving past papers is the cheapest way to meet such pairs before the exam.
Key formulas
- Newton's second law: $\vec{F} = \frac{d\vec{p}}{dt} = m\vec{a}$ (constant mass)
- Impulse: $J = F\Delta t = \Delta p$
- Static friction: $f_s \le \mu_s N$; kinetic friction: $f_k = \mu_k N$
- Largest acceleration from friction on a level surface: $a_{max} = \mu_s g$
- Angle of repose: $\tan\theta = \mu_s$
- On an incline: smooth $a = g\sin\theta$; rough, sliding down $a = g(\sin\theta - \mu_k\cos\theta)$
- Centripetal force: $F = \frac{mv^2}{r} = m\omega^2 r$
- Banked road, no friction: $\tan\theta = \frac{v^2}{rg}$
- Level circular road, friction only: $v_{max} = \sqrt{\mu_s rg}$
- Apparent weight in a lift with acceleration a: $m(g + a)$ going up, $m(g - a)$ going down
Common traps
- Using $\mu_s N$ as the friction force when the body is not about to slip. Static friction is only as large as needed. $\mu_s N$ is its upper limit.
- Forgetting that mass cancels. In many friction and banking questions the answer does not depend on mass. If you find yourself needing a mass that is not given, re-check the physics.
- rpm versus rad/s. In ratio questions you can keep rpm throughout, as in questions 4 and 5. In absolute calculations convert: $1\ \text{rpm} = \frac{2\pi}{60}\ \text{rad/s}$.
- Reading the wording. "Minimum wear and tear", "no tendency to skid" and "optimum speed" all mean the frictionless banking condition.
- Pseudo forces. Use them only if you work in an accelerating frame. Pick one frame and stay in it.
How to study Laws of Motion
- Read chapter 1 of the Pareeksha book Laws of Motion, Work-Energy and Rotation, also available in Hindi and Telugu.
- Draw a free-body diagram for every problem, even easy ones, until it becomes automatic. Most errors in this chapter come from a missing or extra force.
- Practise pulley and connected-block problems from the NEET past papers page, since many of them use figures.
- Take the 15-question chapter test in the NEET section of your dashboard (login needed).
- Continue with the chapters that build on this one: Work, Energy and Power PYQs and System of Particles and Rotational Motion PYQs. For the kinematics side of circular motion, see Motion in a Plane PYQs.
Frequently asked questions
How many questions come from Laws of Motion in NEET?
In the 10 NEET papers from 2021 to 2026 on Pareeksha, the chapter had 13 questions, about 1.3 per paper. It has appeared in every NEET year from 2016 to 2026 in our data.
Which topics are asked most from Laws of Motion?
Friction and circular-motion dynamics lead in the recent papers, including banked roads and tension in whirling strings. Connected-body problems with pulleys also appear, usually with a figure.
Why do I keep getting friction questions wrong?
Usually because static friction is treated as always equal to $\mu_s N$. First check whether the body would move without friction, then find the friction needed to prevent it, and only then compare it with $\mu_s N$.
Is this chapter linked to Work, Energy and Power?
Closely. Work done by friction, the work-energy theorem and motion in a vertical circle all use the force analysis from this chapter. Study the two together.
Are questions repeated across NEET sittings?
Ideas repeat often. The two 2024 sittings both asked the tension-and-speed relation of a whirled bob, once in each direction, as shown above.

Comments (0)
No comments yet. Be the first to share your thoughts.