This is the least-asked chapter in NEET Physics. In Pareeksha's count of 51 digitised NEET and AIPMT papers from 1988 to 2026, not one question is tagged to it. So why write about it? Because it is in the syllabus, because the ideas behind its experiments (the metre bridge, the prism, the Zener diode) are asked regularly inside other chapters, and because a first question on these experiments as experiments could appear in any paper.
This post lists the nine experiments, shows the related past questions that NEET has already asked, and gives a short revision plan. The other half of the unit, on measurement, mechanics and heat, is covered in its own post.
The experiments in the syllabus
The NEET (UG) 2025 syllabus published on NTA's website lists 18 experiments in Unit 20, Experimental Skills, and asks for familiarity with the basic approach and observations of each. Experiments 10 to 18 are the electricity, optics and electronics ones. In our own words:
| No. | Experiment | What it finds |
|---|---|---|
| 10 | Metre bridge | Resistivity of the material of a wire |
| 11 | Ohm's law | Resistance of a wire from a V–I graph |
| 12 | Half-deflection method | Resistance and figure of merit of a galvanometer |
| 13 | Parallax method | Focal length of a convex mirror, a concave mirror and a convex lens |
| 14 | Prism | Graph of angle of deviation against angle of incidence |
| 15 | Travelling microscope | Refractive index of a glass slab |
| 16 | p-n junction diode | Characteristic curves in forward and reverse bias |
| 17 | Zener diode | Characteristic curve and reverse breakdown voltage |
| 18 | Identification | Telling a diode, LED, resistor and capacitor apart in a mixed collection |
Check the NEET 2027 information bulletin for the syllabus when it is released.
How often NEET asks these experiments
| Period | Questions tagged to this chapter |
|---|---|
| AIPMT papers, 1988–2015 | 0 |
| NEET papers, 2016–2026 (18 sittings) | 0 |
| NEET papers, 2021–2026 (10 sittings) | 0 |
That is the honest answer: none so far. Its sister chapter has been asked a little, with 6 questions in the 2021–2026 papers, mostly on reading instruments such as the vernier calliper and screw gauge. You can see both at the bottom of the NEET chapter-wise weightage table.
But the physics behind these nine experiments is asked often. Current Electricity had 25 questions in the 2021–2026 papers, the most of any Physics chapter, Ray Optics had 19 and Semiconductor Electronics had 18. Some of those questions read almost like lab questions. The ones below are examples.
Past questions that test these experiments
These questions are tagged to other chapters in our data (or, for the first one, to the measurement experiments), but each one tests an idea from the list above. Each is copied from the paper with its official answer; the explanations are ours.
Question 1 (NEET 2026 re-exam, Q20)
Which of the following measurements require 'index correction' ?
- (A) Measurement of resistance of a wire using meter bridge
- (B) Measurement of gravitational acceleration using simple pendulum
- (C) Measurement of focal length of lenses using optical bench
- (D) Measurement of speed of sound using resonance tube
Answer: (C)
On an optical bench, the distance read off the scale between two uprights need not equal the true distance between the lens and the needle, because the index marks may not line up with them. Placing a rod of known length between them gives the index error, which is then applied to every reading. This is the focal-length experiment (number 13 in the table). Paper: NEET 2026 re-exam.
Question 2 (NEET 2016 Phase 2, Q152)
An air bubble in a glass slab with refractive index 1.5 (near normal incidence) is 5 cm deep when viewed from one surface and 3 cm deep when viewed from the opposite face. The thickness (in cm) of the slab is
- (A) 8
- (B) 10
- (C) 12
- (D) 16
Answer: (C)
Real depth $=$ refractive index $\times$ apparent depth. From one face the bubble is $1.5 \times 5 = 7.5$ cm deep; from the other, $1.5 \times 3 = 4.5$ cm. Thickness $= 7.5 + 4.5 = 12$ cm. The same relation, $\mu = \frac{\text{real depth}}{\text{apparent depth}}$, is what the travelling microscope experiment (number 15) uses. Paper: NEET 2016 Phase 2.
Question 3 (NEET 2022 Phase 2, Q162)
The incorrect statement about the property of a Zener diode is :
- (A) p and n regions of Zener diode are heavily doped
- (B) Zener voltage remains constant at breakdown
- (C) It is designed to operate under reverse bias
- (D) Depletion region formed is very wide
Answer: (D)
Heavy doping makes the depletion region of a Zener diode very thin, not wide. A thin region gives a strong field at a low reverse voltage, which is what causes the sharp breakdown that experiment 17 measures. Paper: NEET 2022 Phase 2.
Question 4 (NEET 2021, Q23)
Consider the following statements (A) and (B) and identify the correct answer.
(A) A zener diode is connected in reverse bias, when used as a voltage regulator.
(B) The potential barrier of p-n junction lies between 0.1 V to 0.3 V.
- (A) (A) and (B) both are correct.
- (B) (A) and (B) both are incorrect.
- (C) (A) is correct and (B) is incorrect.
- (D) (A) is incorrect but (B) is correct.
Answer: (C)
Statement A is correct. Statement B is not true in general: the barrier is about 0.7 V for silicon and about 0.3 V for germanium. In the diode characteristic experiment (number 16), this barrier shows up as the knee voltage, after which the forward current rises steeply. Paper: NEET 2021.
Question 5 (NEET 2018, Q157)
In a p-n junction diode, change in temperature due to heating
- (A) affects only reverse resistance
- (B) affects only forward resistance
- (C) does not affect resistance of p-n junction
- (D) affects the overall V - I characteristics of p-n junction
Answer: (D)
Heating creates more electron-hole pairs, which changes both the forward current at a given voltage and the reverse saturation current. The whole V–I curve shifts, which is also why the experiment is done without letting the diode heat up. Paper: NEET 2018.
A metre-bridge worked example
NEET 2020 (Phase 1) asked a metre-bridge question of this type. A wire in the left gap balances a 10 Ω resistor in the right gap at a point dividing the bridge wire in the ratio 3 : 2. If the wire is 1.5 m long, what length of it has a resistance of 1 Ω?
At balance, $\frac{X}{10} = \frac{3}{2}$, so $X = 15$ Ω. The wire is 1.5 m long, so 1 Ω corresponds to $\frac{1.5}{15} = 0.1$ m. The official answer was $1.0 \times 10^{-1}$ m.
Formulas and facts to revise
| Experiment | What to remember |
|---|---|
| Metre bridge | $S = R\frac{100 - l}{l}$, with $l$ in cm from the end where $R$ is; $\rho = \frac{S\pi d^2}{4L}$; keep the balance point near the middle and swap $R$ and $S$ to cancel end errors |
| Ohm's law | Slope of a V–I graph is $R$; slope of an I–V graph is $1/R$ |
| Half deflection | $G = \frac{RS}{R - S}$; figure of merit $k = \frac{E}{(R + G)\theta}$, current per division |
| Parallax method | $\frac{1}{v} + \frac{1}{u} = \frac{1}{f}$ for mirrors and $\frac{1}{v} - \frac{1}{u} = \frac{1}{f}$ for lenses, with the sign convention; index correction on the bench |
| Prism | The i–δ graph has one minimum; $\mu = \frac{\sin\frac{A + \delta_m}{2}}{\sin\frac{A}{2}}$ |
| Glass slab | $\mu = \frac{\text{real depth}}{\text{apparent depth}}$ |
| p-n diode | Knee voltage about 0.7 V (Si); tiny reverse current until breakdown |
| Zener diode | Used in reverse bias; voltage stays nearly constant after breakdown |
| Identification | A resistor conducts both ways equally; a diode conducts one way; an LED conducts one way and glows; a capacitor shows a brief current that dies away |
How to study this chapter
Because no question has been tagged to it yet, give it a small, fixed amount of time and no more.
- Read the chapter once in the Experimental Skills book on Pareeksha (also in Hindi and Telugu). Spend about two hours.
- Learn the formula table above and the shape of three graphs: the i–δ curve for a prism, the forward and reverse diode curve, and the Zener curve.
- Practise the parent chapters. Metre-bridge, prism and diode questions are asked under Current Electricity, Ray Optics and Semiconductor Electronics. Solve those on the NEET past papers page.
- Take the chapter test for this chapter in the NEET chapter-wise tests (login needed) once you have read it.
- For both halves of the unit together, see our guide to NEET experimental skills.
Frequently asked questions
Has NEET ever asked a question on these experiments?
Not as a separate chapter in any of the 51 papers digitised on Pareeksha, from AIPMT 1988 to the NEET 2026 re-exam. Questions on the same ideas, such as the metre bridge, real and apparent depth and the Zener diode, are regularly asked under other chapters.
Should I skip this chapter?
No, but keep it short. The experiments are in the syllabus, a question could appear in any paper, and most of the content overlaps with chapters you are already studying. Two or three hours is enough.
Which experiment is most likely to be asked?
We cannot predict that. The safest preparation is to know the formula and the graph for each of the nine, with a little more attention to the metre bridge and the diode curves, since their parent chapters carry the most weight.
What is the figure of merit of a galvanometer?
It is the current needed to make the pointer move by one division. A smaller figure of merit means a more sensitive galvanometer.
Why should the balance point in a metre bridge be near the middle?
The error in the unknown resistance is smallest when the balance length is close to 50 cm. That is also why the known resistance is chosen so that the balance point falls near the middle of the wire.

Comments (0)
No comments yet. Be the first to share your thoughts.